This cable connects your radio to your camera’s remote shutter release terminal to enable remote camera triggering. This standard cable works with most PocketWizard radios but has no half-press control, and is for basic remote triggering only.
A N90M3–P (PreTrigger) cable works with most PocketWizard radios. This pre-trigger cable has a switch that allows you to toggle half-press on or off at the camera position, but not remotely. A N10-ACC or N10-ACC-200 cable allows a compatible PocketWizard radio to independently control both half-press and full-press functions, as well as relay E-TTL signals to compatible flashes when using FlexTT5s.
Standard Remote Cable for connecting a Plus II or MultiMAX with no ACC port to a Nikon 10-pin remote terminal.
Cable length: 3' (91.5 cm)
From: 1/8" (3.5 mm) mono miniphone
To: Nikon 10-pin remote shutter release terminal
Compatible with the following radios:
-
Plus II: Use this cable to remotely fire your camera.
-
Plus III: This cable can remotely fire your camera but it has no half-press control. Use aN10–ACC or N10-ACC-D200 cable for best results.
-
FlexTT5: This cable can be used to remotely fire your camera, like a N90M3–P cable with a FlexTT5, but your remote camera will not be able to relay an E-TTL signal to Speedlites. Use a N10–ACC or N10-ACC-D200 cable for best results. Learn more here.
-
MultiMAX with no –ACC port: Use this cable to remotely fire your camera.
-
MultiMAX with –ACC port: This cable can remotely fire your camera but it has no half-press control. Use a N10–ACC or N10-ACC-D200 cable for best results.
Please see this PocketWizard Wikifor more details.
Compatible with cameras using Nikon's 10-pin remote shutter release terminal.
